界面快照:
描述
本软件提供简易的cisco ccna 路由实验练习环境, , 提供73个路由/交换实验:
(1) IP Service 1 : Dynamic NAT Static NAT PAT (port address translation) Extended ACL Standard ACL Name ACL Time ACL IPv6 ACL(1) IPv6 ACL(2)
(2)IP Service 2 : VRRP (track on serial) HSRP (track on serial) VRRP/IP SLA (track on ethernet) HSRP/IP SLA (track on ethernet) GLBP(Gateway Load Balance Protocol) DHCP server DHCP relay Enable NAT on DHCP router DHCPv6 auto config
(3)IP Service 3 : DHCPv6 stateless DHCPv6 stateful PPP CHAP authentication PPP PAP authentication PPP multilink GRE tunnel NTP NTP authentication
(4)IP Routing 1: EIGRP manual summary EIGRP unequal cost load balance EIGRP passive interface EIGRPv6 EIGRP authentication EIGRPv6 authentication EIGRP redistribution OSPF Route EIGRP redistribution RIP Route EIGRP redistribution static Route
(5)IP Routing 2: OSPF normal area OSPF stub area OSPF totally stub area OSPF NSSA area OSPF totally NSSA area OSPF virtual link OSPFv3 (OSPF for IPv6) OSPF authentication (by area) OSPF authentication (by interface)
(6)IP Routing 3: OSPF route summary on ABR OSPF route summary on ASBR OSPF redistribution RIP route OSPF redistribution static route RIP route filter OSPFv3 virtual link Policy base route RIPng Inter VLAN Routing
(7)IP Routing 4: BGP authentication BGP local preference (1) : config global BGP local preference (2) : config network prefix BGP MED BGP neighbor BGP neighbor use loopback interface BGP summary address
(8)Switch 1: Tacacs+ on switch Tacacs+ on router Radius on switch Radius on router Reset router Reset switch Config Telnet Config SSH Restricted IP access
(9)Switch 2: L2 EtherChannel PAgP L3 EtherChannel PAgP L2 EtherChannel LACP L3 EtherChannel LACP